SIFAT FISIKA PAPAN SEMEN DARI CAMPURAN LIMBAH BATANG SAWIT

Rosmaina Julianti Nadapdap, Yuyu Rahayu, Susilo Budi Husodo

Abstract


This study investigates the physical properties of cement boards made from oil palm trunk waste and evaluates the effect of varying cement-to-palm trunk waste ratios (70:30, 75:25 and 80:20). The independent variable is the cement-to-waste ratio, and the dependent variables include density, moisture content, thickness swelling, and water absorption. Results show that the density of the boards ranges from 0.70 g/cm³ to 1.02 g/cm³, moisture content from 6.79% to 14.49%, thickness swelling after 24 hours of immersion from 17.50% to 70.00%, and water absorption from 40.41% to 68.04%. Ratio 70:30 and 75:25 meet Indonesian National Standard (SNI) criteria for density and moisture content, but thickness swelling exceeds the standard, indicating poor dimensional stability. Increasing cement content improves density and reduces moisture content, but challenges remain in achieving dimensional stability and water resistance. These findings suggest that while oil palm trunk waste can be used in cement board production, further optimization, such as additive incorporation or feedstock modification, is needed to enhance water resistance and stability.

Full Text:

PDF

References


Antaranews. (2023). Diakses dari (https://www.antaranews.com).

Armaya, R. (2012). Karakteristik Fisis dan Mekanis Papan Semen Bambu Hitam (Gigantochloa Atroviolancea Widjaja) Dengan Dua Ukuran Partikel. Skripsi. Universitas Sumatra Utara, Medan.

Engehausen, N., Benthien, J. T., & Lüdtke, J. (2024). Influence of Particle Size on the Mechanical Properties of Single-Layer Particleboards. Fibers, 12(4), 32. (https://doi.org/10.3390/fib12040032)

Ginting, E. U., Iswanto, A. H. A., & I, A. (2016). Sifat Fisis dan Mekanis Papan Partikel dengan Menggunakan Campuran Perekat UF dan PF pada Berbagai Suhu Pengempaan. Journal Lignocellulose Technol, 01, 51-57.

Hamedani, H., Moini, M., & Rahimi, S. (2013). Investigation of hydration heat in wood-based composites for particleboard production. Journal of Materials Science Research, 2(4), 23-30. (https://doi.org/10.5539/jmsr.v2n4p23)

Haygreen, J. G., & Bowyer, J. L. (1996). Hasil Hutan dan Ilmu Kayu: Suatu Pengantar. (A. H. Sujipto, Penerjemah). Gajah Mada University Press. (Terjemahan dari: Forest Product and Wood Science: An Introduction).

Hermawan, A., Diba, F., Mariani, Y., Setyawati, D., & Nurhaida. (2014). Sifat Kimia Batang Kelapa Sawit (Elaeis guinensis Jacq) Berdasarkan Letak Ketinggian dan Kedalaman Batang. Fakultas Kehutanan Universitas Tanjungpura.

Japanese Industrial Standard (JIS). (1992). Cement Board. JIS A 5417. Japanese Standard Association, Japan.

Kementerian Pertanian. (2020). Statistik kelapa sawit Indonesia. Kementerian Pertanian Republik Indonesia.

Lim, A., Chew, J.J., Ngu, L.H., Ismadji, S., Khaerudini, D.S., & Sunarso, J. (2020). Synthesis, characterization, adsorption isotherm, and kinetic study of oil palm trunk-derived activated carbon for tannin removal from aqueous solution. ACS Omega, 5, 28673–28683.

Nuryawan, A., Sutiawan, J., Rahmawaty, Masruchin, N., & Bekhta, P. (2022). Panel Products Made of Oil Palm Trunk: A Review of Potency, Environmental Aspect, and Comparison with Wood-Based Composites. Published: 26 April 2022.

Odeyemi, S. O., Abdulwahab, R., Adeniyi, A. G., & Atoyebi, O. D. (2020). Physical and mechanical properties of cement-bonded particle board produced from African balsam tree (Populous Balsamifera) and periwinkle shell residues.

Results in Engineering, 6, 100126. (https://doi.org/10.1016/j.rineng.2020.100126)

Pangestu, A., Ismiasih, & Purwadi. (2021). STRATEGI PETANI DALAM MELAKUKAN PEREMAJAAN (REPLANTING) PADA PERKEBUNAN KELAPA SAWIT DI DESA BANDAR TONGAH KEC. BANDAR HULUAN, KAB. SIMALUNGUN, SUMATERA UTARA. Journal Agrifitia, 1(1).

Quiroga, A., Marzocchi, V., & Rintoul, I. (2016). Influence of wood treatments on mechanical properties of wood–cement composites and of Populus Euroamericana wood fibers. Composites Part B: (https://doi.org/10.1016/j.compositesb.2015.08.069)

Simatupang. (1974). Pembuatan dan Penggunaan Campuran Semen dan Kayu Sebagai Bahan Bangunan. Kehutanan Indonesia, 390-392.

Standar Nasional Indonesia (SNI) 03-2105-2006.

Standar Uji Bahan Bangunan Indonesia. (1986). PB.1989:3.2-8.

Suryani, E., Marlina, R., & Yusuf, R. (2019). Dampak lingkungan dari pembakaran limbah kelapa sawit dan alternatif pemanfaatannya. Jurnal Ilmu Lingkungan, 17(1), 43-54.

Thomas, R. J., Collins, M. P., & Lee, S. (2019). Effect of organic fibers on the physical and mechanical properties of cement composites. Materials Science Forum, 956, 101-108.

Wijoyo, J. (2017). Sifat fisika Papan Semen Partikel Limbah Serbuk Gergaji Kayu Jati (Tectona grandis). Universitas Mataram, Mataram.

Yogi, Y., Yani, A., & Nurhaida, N. (2020). Sifat fisika dan mekanik papan semen berdasarkan komposisi dan ukuran serat sabut kelapa (Cocos nucifera). Jurnal Hutan Lestari, 9(4), 48656. https://doi.org/10.26418/jhl.v9i4.48656




DOI: https://doi.org/10.31884/jtt.v11i2.806

Refbacks

  • There are currently no refbacks.


Copyright (c) 2025 JTT (Jurnal Teknologi Terapan)



View Stats

 

 Creative Common Attribution-ShareAlike 4.0 International (CC BY-SA 4.0)